Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Crosley 158 Septet
#1

Found a Crosley 158, 7 tube cathedral, in an indoor flea market in original complete very good condition non restored. It was made in '32' for the '33' model year. Tubes in place are 2-58, 2-56, 1-57, 1-42 & 1-80. Superhet IF= 181.5KC. A pic is available at the Radio Attic. Don't know much about early Crosley's as have been concentrating on Philco, Zenith and Airline. Is it common or somewhat rare...should I grab it?
Thanks, John
#2

Hello, John: they are fairly uncommon from my perspective. They are a decent reciever but can be a pain in the thing you sit on to restore both electrically and cabinet-wise. If this one is in decent shape and not overly pricey I would grab it.

The reason I say that the cabinets are tough is that the wood lamination often bubbles and separates, and often the wood on the arch splits along the wood grain.
#3

Hello again, John: did you get the Crosley?
#4

Not yet, going to go back and look at it a second time. I think it will be a good deal as my initial look showed it to be in excellent condition. Will have to wait till the first of the month when retirement check comes in as getting late in the month. Rebuilding a Solar CE cap analyzer, Heathkit T3 signal tracer, B&K 177 Vtvm, BK Precision 1803A freq. counter and have a Heathkit IP-32 power supply coming in...so keeping busy. Icon_thumbup John




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM

[-]
Who's Online
There are currently 3052 online users. [Complete List]
» 2 Member(s) | 3050 Guest(s)
AvatarAvatar

>