Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-116 value??
#1

I have a philco model 37-116 that is in very good condition. Could anyone tell me what it is worth and how I would find a buyer.
#2

We don't normally give appraisals without photos, one person's idea of very good condition can be very different from someone else. There is also the factor of the electrical condition of the set, unrestored is one thing, electrically restored is another, butchered with parts missing or incorrect parts is another.
Regards
Arran
#3

Hi and welcome!

As Arran mentioned, photos would be very helpful.

There were two versions of the 37-116 - one with the Automatic Tuning mechanism (a large apparatus below the dial, vaguely resembling a telephone dial) and one without. The one without was called the "Standard" and the one with Automatic Tuning was called the "De Luxe."

http://www.philcoradio.com/gallery/1937a.htm#o
http://www.philcoradio.com/gallery/1937a.htm#p

We'll need to know where the radio is located, also. Don't post a street address or a phone number, just a city and state is sufficient.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 5155 online users. [Complete List]
» 1 Member(s) | 5154 Guest(s)
Avatar

>