Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 37-84 refinish advise.
#1

Hello from Ireland!
I have got a Philco 37-84 code 122 radio that I am restoring. It needs to be refinished. It has got a finish that I am not familiar with. It appears to be a painted wood grain effect with lighter and darker stripes No veneer, and it is cracking and flaking off. I was hoping that someone could advise me on the best way or the options of refinishing this cabinet.

Thanks in advance
Frank
#2

Hi Frank,

That is called a "Photo Finish," since it's a paper-based "picture" of wood-grain over the base, cheap wood.

See the PHOTO FINISH links for info and repair from the MISC INFO page on my site:

http://www.philcorepairbench.com/misc.htm
#3

Hi Chuck
Thanks for the quick reply.
I had a look at the site. It looks difficult to achieve a original finish particularly when there is stripes through it.
Thanks again for the info.

Regards
frank
#4

Also search the CABINET RESTORATION section of The Antique Radio Forums at http://www.antiqueradios.com

Photo-finishes have been discussed before at length and others have achieved very good results.

Good Luck!

Sláinte!

Chuck




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Testing a speaker and output transformer Trutone A2-G
Well I have found 315v on the rectifier when cold. Drops off to 280 after 15 minute warmup. Checked pin 3 on both 6F6 t...murf — 04:14 PM
Testing a speaker and output transformer Trutone A2-G
Thanks for the replies, I will check these ideas out and report back. murfmurf — 03:18 PM
Testing a speaker and output transformer Trutone A2-G
Sorry, my mistake. murfmurf — 03:07 PM
Testing a speaker and output transformer Trutone A2-G
MrFixr Honestly, I haven't done that yet and do not want to screw up the threads; maybe you could do it, or we could...morzh — 12:48 PM
Two small radios from France. Restoration and review.
Greetings; I think that it's possible that the assortment of components was the result of post war parts shortages, a...Arran — 12:18 PM
Philco model 38 code 121 not receiving signal.
Unfortunately I can't inject any audio into the volume control. It is in the primary circuit of the antenna coil, not in...Stormlord5500 — 09:32 AM
Philco model 38 code 121 not receiving signal.
Sounds good Gary I'll do that. I have plenty of stuff like that I can scrounge up. I am still kind of new to all this so...Stormlord5500 — 08:47 AM
Philco Battery-WWII vintage
Seems to me that this a general purpose or radio filament 6V battery of very high amp-hour capacity and very high "...MrFixr55 — 08:08 AM
Testing a speaker and output transformer Trutone A2-G
Hi Morzh, From my end, no. I did not know that there are 2 threads on this topic. Maybe it should be combined.MrFixr55 — 07:13 AM
Testing a speaker and output transformer Trutone A2-G
Any reason for the 2nd copy of the thread?morzh — 10:22 PM

[-]
Who's Online
There are currently 275 online users. [Complete List]
» 2 Member(s) | 273 Guest(s)
AvatarAvatar

>