Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 37-650
#1

Hey all this is my first post and first radio project.I found the problem to do with the drawing and the schematic for the philco 37-650...and then found it on your site,My question is i believe mine is all original so as long as i replace componets where they were ..should it work..assuming it worked from the factory?thanks and cheers Mike
#2

Mike123, hi. provided the set is as it came from the factory your method of replacing individual components one at a time will work. I assume you are talking about resistors and caopacitors. Coils, transformers and other items are not that easy to replace and some ay be damaged. The first task should be to change the filter caps (electrolitic) in the power supply then bring it up with a dim bulb rig. It may be operating. I would not try powering up until the filter caps are changed. PL




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM
Made mistake & did not label connection
Maybe this is starting to make some sense in my hard head.  Is this why the wire in question was not in the great Ron Ra...georgetownjohn — 04:34 PM
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM

[-]
Who's Online
There are currently 2556 online users. [Complete List]
» 3 Member(s) | 2553 Guest(s)
AvatarAvatarAvatar

>