Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Schematic for a 14B - Never mind
#1

Does anybody have a clear schematic for a 14B?

It's done.

Thanks
#2

I'll bet Chuck does. I need to get one too. The one on NA really bad. From the looks of it it ought to be a great playing set. One rf amp, two if amps, and three stages of audio... Plus a shadowgraph. I've got the 14 modern version.
Terry
#3

I'm about 3/4 of the way through this one now. by the time I find a ledgable schematic, I won't need it. I'll let you know in the morning how well it works.

Interesting that a lot of the dogbone resistors in this one seem to have drifted down rather than up, or they were lower to start with and did not drift (much).

Yes, a 42 driving 2 more in PP. Should be loud, anyway.
#4

Yes, Phlogiston, I have an original Model 14 Service Bulletin No. 176, in my archives,
and all published Production Change Notes from Philco. Shadow Meter info as well.

Regards,
Chuck
#5

Thanks guys, but it is all done, just takes a couple of hrs longer without a good schematic. It is hard to tell which contacts are used in the Bakelite caps without one.

It is a very nice radio. Picked up lots of stations with only a 18" antenna.




Users browsing this thread:
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently no members online.

>