Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-3XX - back panel?
#1

Did the 38-3XX console originally have a back panel on it? If so, what did it look like? And did it serve any functional purpose other than to keep the kids from electrocuting themselves? My 38-3XX has some clips around the back edge that look like they MIGHT have held a panel at one time, but if there was one it was long gone by the time I got the set.
#2

Yes it did have a back when it was new. See this thread: http://www.philcoradio.com/phorum/showth...p?tid=6813
#3

Anybody have a good photo of one? Also, what material was it made of, and how thick?
#4

I think I saw one on epay recently.
Terry
#5

not there now,though. They must have been fairly fragile if so few of them are around now.
#6

Suggestion: Send the fellow in the thread above (Murf) a PM and see if he still has the radio with the back on it and would send you photos.
#7

Did that yesterday & waiting for a reply...
#8

Hello,
I sold mine. Sorry.
Back was just made out of hardboard.
Had a bunch of slots cut in it for ventilation.
Would be easy to make.
Good luck.
murf
#9

thanks!




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4813 online users. [Complete List]
» 1 Member(s) | 4812 Guest(s)
Avatar

>