1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Osc Transformer question 41-315X
bfrohwein
Member
***
Posts: 152
Threads: 11
Joined: Feb 2013
City: Dallas, TX
#16

12-19-2013, 05:42 PM
I Finally got it! just in time, the chassis almost went out the window.. Icon_eek
Find
purplecase
Junior Member
**
Posts: 5
Threads: 2
Joined: Mar 2017
City: Lakewood State, Province, Country: CO
#17

06-22-2019, 08:32 PM
Just to put a bow and icing on this thread, I had the same problem as bfrohwein. Trimmer 20 bottoming out before 580 kz from Signal Gen. could tune in. Per Mondial put a 180p silver mica across C-20 and all is well. Proper tracking high and low with great sensitivity. Thanks all, John.
Find
bfrohwein
Member
***
Posts: 152
Threads: 11
Joined: Feb 2013
City: Dallas, TX
#18

06-24-2019, 11:51 AM
Excellent!   That radio was a bit of a challenge.. still works though.. ;-)
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4942 online users. [Complete List]
» 2 Member(s) | 4940 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration