Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-7 veneer help
#1

I recently bought a table model 38-7 to complement the console I have and it is missing some sections of veneer. The inlaid bands are fine so I thought that patching this might be an option. Since I've never done this before, are similar pieces of veneer available at Lowes etc, or am I better off in trying to find someone with a basket case cabinet who may want to sell it? Hope I didn't bite off more than I can chew with this one.

[Image: http://farm3.staticflickr.com/2270/20781...bd5d7b.jpg]
38-7 by tony_senior, on Flickr

http://www.flickr.com/photos/23116054@N00/2078105906/
#2

Hi Tony

You won't find good veneer at Lowe's. Try Constantine's or Van Dyke online, or you might check with a Woodcraft store in your area.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5658 online users. [Complete List]
» 1 Member(s) | 5657 Guest(s)
Avatar

>