Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Sold one and bought one [radios]
#1

I just finished the Rogers and sold it the next day and then today I went to an estate sale and bought this dictator. I slowly brought it up after inspection and it works but will need a recap and clean up .. i know the cabinet will come put very nice once I strip it.


Attached Files Image(s)
                   
#2

The chassis is as clean as they ever get.
Nice radio.
#3

Very nice find. Is that a brand name or a model perhaps ?
That cabinet will be a real looker when done.
#4

Nice find!
#5

Very nice radio! That one will be a real looker when you get it finished. Good job on the Rogers too!

The artist formerly known as Puhpow! 8)
#6

Dictator used to be the private label brand of the Hudson's Bay Company who sold the sets in their stores and by catalog much like Sears. They were usually made by Grimes-Phonola/Dominion Electrohome. At some point they dropped the "Dictator" name and started labeling their sets as "Baycrest", likely after the war when the word "Dictator" gained an unsavory connotation. Studebaker had a mid priced model of car also named a "Dictator" but dropped the name in favor of "Director" for that reason, then phased out the model line altogether making the "Commander" the mid priced car.
Regards
Arran




Users browsing this thread:
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6712 online users. [Complete List]
» 1 Member(s) | 6711 Guest(s)
Avatar

>