Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Can someone tell me where to find a schematic..
#1

For this little Automatic Radio "Tom Thumb"?

I've found several "Tom Thumb" models in Nostalgia Air, but none seem to match.

   
#2

Try this schematic:
http://www.nostalgiaair.org/Resources/828/M0001828.htm

Carl
Northern Panhandle, WV
#3

Yup that is the same schematic as radiomuseum.org has posted for this radio.
BTW Brenda are you really in south Korea? Is it tough finding antique radios there?
#4

Not tough, impossible. Anything made before WWII has been long gone, pretty much nothing existed here after WWII through the Korean War. And not that much before WWII, because of the Japanese occupation. All there is here is the rare occasional set that made it's way here from Burma or some really rare ones from Europe. Everything now isn't worth owning, just solid state cheap garbage, most of which ends up at the curbside recycler after a year or two. I get all my radios from the US and Canada, mostly via ebay.
#5

Brenda, it really begs the question "are there any other radio collectors in South Korea"? You must have the largest collection over there! Nice to have your help on those pesky radio questions.
Best, Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#6

There are a few others. One is a good friend of mine, and he has over 400 radios in his collection (and a lot of money.. he was head of veterinary medicine at a large university here).
#7

Brenda ,
There is a 1947 Tom Thumb Portable for sale on E-Bay right now with a copy of the Photo-fact.Maybe the seller would copy it for you.

http://www.ebay.com/itm/1947-Tom-Thumb-P...338f02f3e3

Good Luck,
Henry
#8

I looked through all my '47 Sams, & never found a Tom Thumb listed.
According to the index, no photofact was made. May be that there
was one for '48 or 49, but when did the Mfgr. quit production??
On that note, what Co. made these units?
Jim
#9

Brenda, I have the Sams for your radio. I can scan and send it or I can mail you a copy. Which would you like?
#10

Finally found it---13-4. Is that the one you have, Jim?
It was out of place.
#11

Set 23. Maybe shown as 4713-4.
#12

Yes, that's it.
#13

Paging Brenda.
#14

Darn pager.... I must have let the battery go down. (@)@)




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently no members online.

>