Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Marvelo?
#1

Has anyone heard of the radio brand marvelo or maybe a parent company? I was given a 7 tube, 2 thumbwheel dial early radio (trf?) that other than some cut wires and missing both of the audio transformers is in great shape, I would like to restore it to working condition but I can not find any info on the radio or brand name. Although all 7 tube sockets are 4 pin I dont know if it takes all 01a's or not. I will post a pic later.
Thanks for any info,
Todd
#2

Marvelo was a trade name used by the Radolek Co.

Mike Koste
Gobs of Knobs
Zucksville, PA
#3

Thanks, but the marvelos they have on nostalgia air under radiolek are newer ac schematics.
Even though early radios are simple designs how would one know what tubes and transformer ratios to use without a schematic?




Users browsing this thread:
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 4660 online users. [Complete List]
» 3 Member(s) | 4657 Guest(s)
AvatarAvatarAvatar

>