Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

FM Reception 46-480
#1

Hope all had a nice holiday weekend. I get lousy FM reception in my area. Just a couple of stations and they are somewhat fuzzy. My 46-480 picks up several stations with the antenna I made but I have to turn the volume all the way up to barely hear anything. AM stations are just fine. Can anyone shed some light on the FM? I have a modern radio that picks up the same stations but I get plenty of volume from that radio. Thanks!
#2

Hi

Have all paper and electrolytic capacitors been replaced? Tubes checked? Set aligned? And...is the set's FM antenna connected properly?

--
Ron Ramirez
Ferdinand IN
#3

Thanks! Yes to all of the above. Everything went smoothly. I did have a problem with the Loctal sockets after I pop-riveted them back into the chassis. The heads of the rivets wouldn't allow the tubes to seat properly. I filed the heads and cleaned all the sockets per instructions found in another post and the tubes seat well now.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM
Philco Predicta Siesta picture over time getting dimmer
I found that the wire insulation was burnt.  The fly back needs corona dope! Why would someone put that there?Platinumblonde36 — 01:09 AM
Philco Predicta Siesta picture over time getting dimmer
This is what it looked like beforePlatinumblonde36 — 01:01 AM

[-]
Who's Online
There are currently no members online.

>