1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
RCA 8t plays again/REDO DIAL
Fred Taylor
Phorum Expert
*****
Posts: 765
Threads: 147
Joined: Aug 2012
City: Dallas, TX
#16

07-09-2015, 10:20 AM
(07-09-2015, 10:13 AM)Dan Walker Wrote:  I think it looks better now that you have changed the color of the escutcheon.  It looks more original.
   Nice job on the cabinet

Thanks Dan, some guys were telling me the escutcheon was polished from factory, after researching a little I don't think it was so I went ahead and darkened it, looks a lot better.
Find
SteveG
Senior Member
****
Posts: 330
Threads: 40
Joined: May 2015
City: Sanger, CA State, Province, Country: California
#17

07-10-2015, 04:57 PM
Fred,
Very good! I'm liking that bezel now! What did it you use on it?
Steve
Find
kj0002
Junior Member
**
Posts: 41
Threads: 4
Joined: Jun 2011
City: Fort Myers, FL
#18

07-11-2015, 08:47 PM
Hi Fred

That is an absolutely beautiful job you did on that!!  I have the previous year 1935 T8-14 with the round dial and also the little 1936 5T, both are very sensitive and 2 of my favorite radios!!

Sincerely

Keith Jansen
Find
Fred Taylor
Phorum Expert
*****
Posts: 765
Threads: 147
Joined: Aug 2012
City: Dallas, TX
#19

07-12-2015, 08:06 PM
(07-10-2015, 04:57 PM)SteveG Wrote:  Fred,
Very good!  I'm liking that bezel now! What did it you use on it?
Steve
I sprayed a few light coats of dick van dike brown from Mohawk, its a toner color for wood refinishing, and is lacquer base. Looks pretty good ,gives it that patina (aged) look again Icon_eek I thought about hanging it over the ash tray when I smoke , to age the dial cover Icon_think Icon_think Icon_think Icon_think Icon_think Icon_think
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 4680 online users. [Complete List]
» 2 Member(s) | 4678 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)