Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Phlaky Lacquer
#1

I'm starting work on the finish of 2 cabinets. One is a Philco 650 and the other is a 1940 Farnsworth. The finish on the Farnsworth has flaked off slightly in some spots and heavily in others (see pics). I have been reading this forum and have not yet run across a discussion on how to proceed in either case. Will I have to strip the finish or is there a way to repair?  The 650 has a few areas near the bottom that are slightly flaked off.

Rod
#2

I cant tell if that is photofinish...

If it isnt then you will have to strip it. No way to match the toner and the flaking is too unstable.
If it is photofinish you can recreate it on a computer or if you have artistic talents then you can do it with paints.

I completely redid the photofinish on a philco radio clock lamp and it was not that hard.

First we need to know what the finish is.

Kirk

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6
#3

Kirk - Sorry about the phuzzy photo. It's veneer with toned lacquer. The 2 inch wide horizontal piece at the bottom of the pic halfway down the cabinet might be photo finish and I probably won't have to do anything with that. So you're saying I should strip the badly flaked off area? What about the occasional single tiny area?




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 3786 online users. [Complete List]
» 2 Member(s) | 3784 Guest(s)
AvatarAvatar

>