Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Crosley 03CA
#1

I recently worked on a friend's console, Crosley 03CA.  She has owned it for many years and it finally quit playing.  She asked me to see if I could help it. It belonged to her grandmother and she remembered it playing at grandma's house and sounding like a jukebox. 

After re-capping, replacing bad tubes, and a few resistors, I could see why she thought it sounded good.  It's not a WLW, but it's above average for 1940ish radios.

It has a BEAUTIFUL dial and dial glass; I would say perfect, especially after nearly 75 years.  Cosmetically, the cabinet is about an 8 out of 10, original finish, but knobs which are badly warped and mis-shapened, and one push button on the presets is missing.  However, I found a website that has reproductions should she wish to replace them. 

All the bands worked without any tinkering...a very nice specimen.  Almost wish I could have kept it, but that would mean getting rid of one of my consoles---which would be hard to do. 


Attached Files Image(s)
   
#2

I had one of those many years ago. Never did get it working , had trouble wrapping my head around the direct coupled triode output stage. Nice looking one!!

Terry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently no members online.

>