Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

46-1209
#1

Hi I am new to the Antique Radio Scene and just purchased a 46-1209 over the net off ebay.
Looks like its in pretty good shape. I was wondering if there was a going rate for a good condition
46-1209? I paid $99 plus shipping which was quite a bit -

That being said I have a very specific purpose for this radio that might make some here cringe.
I am going to update it - yes update it in ways that most here wont like. I plan to restore the cabinent
and gut the inside which will be replaced with a small computer and a touch screen that will be located
where the turntable was. Its a unique project that I would love to share here and receive advice on
restoration for the exterior.

Anyway I am wondering what good price is for the model I just bought that seems in better then average shape.

Thanks
Matt
#2

Matt, Some will be a little upset about your project, but a post war with a phono probably isn't a really rare piece.
Might post your location so anybody close could get the chassis/speaker etc. Some of the parts are nice to have.
Questions on cabinet refinishing probably belong in the cabinet forum section. Lot of experts there.




Users browsing this thread:
[-]
Recent Posts
My Philco 37-116 Restore
Hello MrFixr55, Thank you for taking the time to explain. I measured 50 volts where you say. Today the 370 volts at ...dconant — 12:51 PM
462ron
Oh that sucks. It’s something easily overlooked. Hopefully it’s nothing more than a resistor! Ron462ron — 08:08 AM
Philco 46-480 Electronic Restoration
Just confirmed that you are correct. It’s the function generator. I connected the signal output probe to one of the inpu...jrblasde — 07:52 AM
Philco 46-480 Electronic Restoration
Ouch, you may be right. Yes, it is solid state. It’s the signal output of my oscilloscope. May be time to crack that ...jrblasde — 07:27 AM
462ron
If you didn’t put a DC blocking cap between the signal generator probe and the plate of the 1st IF it’s possible you ble...462ron — 07:07 AM
My Philco 37-116 Restore
Hi DConnant, The reason why C127 is isolated from ground is because sets of this vintage did not have the center tap...MrFixr55 — 01:07 AM
Philco 46-480 Electronic Restoration
The shield is on the 6H6. It was, in fact, a missing jumper to connect the main chassis ground to the RF chassis grou...jrblasde — 10:58 PM
Zenith H725
When dealing with noise on power lines, time to get my Jackery 240 out. Talk about clean can hold a portable am radio ne...David — 08:52 PM
Zenith H725
Arran - I bet you're right probably vinyl, there was no rubber smell when desoldering it, which you often get with the o...EdHolland — 08:23 PM
Zenith H725
Ed; It was very likely vinyl covered wire given the vintage of the set, there was some rubber/gutta percha wire used ...Arran — 06:34 PM

[-]
Who's Online
There are currently no members online.

>