06-17-2016, 02:09 PM
Very nice!
![Icon_clap Icon_clap](https://philcoradio.com/phorum/images/smilies/icon_clap.gif)
![Icon_clap Icon_clap](https://philcoradio.com/phorum/images/smilies/icon_clap.gif)
![Icon_clap Icon_clap](https://philcoradio.com/phorum/images/smilies/icon_clap.gif)
Western Auto Radio Restore
06-17-2016, 02:09 PM
Very nice!
![]() ![]() ![]()
06-17-2016, 03:39 PM
Uses a ballast tube?? I see it has a 68v 300ma heater string.
Terry
06-17-2016, 05:32 PM
Thanks Bob. I appreciate that.
Terry it doesn't have a ballast tube. It had a BC resistor 17a -30 ohm 3watt & 17b- 106 ohms. 9 watt. I replaced it with two power resistors. First time I used 10 watts for both but they were very hot think I could fry an egg on the chassis. So I went with 2 power resistors that I bolted to the chassis 1-10 watt for the 3 watt & a25 watt for the 9 watt. It helped but still pretty darn hot. Here is the schematic. If you want to take a look. http://www.nostalgiaair.org/pagesbymodel...023640.pdf
06-18-2016, 02:06 AM
Stunning! Awesome!
« Next Oldest | Next Newest »
Users browsing this thread: |
![]() |
![]() |