Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5

grill cloth woes
#1

Hi guys,  I have a Philco 44 highboy that I restored a couple of years ago.  Getting ready to put in an order for some grill cloth.  What is on there now isn't bad at all but the cloth is heavy and the wrong pattern.  I would like to get as close as possible to the original.  Looking at Radio Daze inventory, would "GRC02" pattern be the closest?  http://www.radiodaze.com/grille-cloth/  I am having a hard time finding what the original pattern looked like.  There should be an attached pic of the radio.

Thanks


http://s350.photobucket.com/user/Don_Ray...sort=3&o=0
#2

No one ever made an accurate pattern of the cloth which your 44H had originally.

That said...Kenny Richmond's "Whiskey Rayon" or the GRC02 from Radio Daze would be good substitutes.

http://richmonddesignsinc.com/grille_cloth_product_page

http://www.radiodaze.com/grille-cloth-02-item-grc02/

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron, that is the one I was going for, just wasn't quite sure if that was the closest.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

[-]
Who's Online
There are currently 5035 online users. [Complete List]
» 1 Member(s) | 5034 Guest(s)
Avatar

>