Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Whatzit on 42-1010
#1

On my 42-1010 console, there is a small black cast metal box mounted to the cabinet next the the chassis. The harness to the beam of light pickup connects to this box with a 4-pin plug, and there is an RCA jack on the box as well. What purpose does this box serve and what's inside?
#2

Phono Input Transformer, Part No. 89 on the schematic.
#3

Chuck Schwark Wrote:Phono Input Transformer, Part No. 89 on the schematic.

Which would explain why I had no audio from the phono until I reconnected it. Audio levels came up a bit with the contacks cleaned, but I'm betting that the cell is pretty much shot as I just can't get much volume without turning the volume knob up at least 3/4 of the way. Not a big thing until I forget and switch to radio and blast the furniture across the room!

Once I get the dial restrung and get the chassis back in the cabinet, I'll tackle replacing the cell.
#4

The link to Don Cochrane on my BOL page. Don rebuilds these BOL cells.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM
Made mistake & did not label connection
Maybe this is starting to make some sense in my hard head.  Is this why the wire in question was not in the great Ron Ra...georgetownjohn — 04:34 PM
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM

[-]
Who's Online
There are currently no members online.

>