Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

16b and model 20 pwr trans
#16

To be sure there are many 16B tombstones which have the 5 band chassis and which are factory correct this way. They also sold 16L consoles with 5 band chassis as well. You can tell if yours is correct by checking a couple of things. The earlier 16B tombstones have aless angled or peaked top than the later 4 banders. Also, the holes in the front panels are different. The 5 band chassis has a small hole at the tuning knob, as it has a single shaft which pulls in and out for fast and slow tuning. The 4 bander cabinets have a larger hole for the dual coententric knobs. The 5 band chassis in the 16B tombstone always has the 10 inch speaker hard wired to the chassis through the chassis, whereas the console sets used a plug in speaker arrangement.
#17

that settles it then,the chassis is not original,the speaker is not hardwired. no real biggee for me though. the seller is local and i'm familiar with him though not really friends. i emailed him about the "original " statement in the auction not quite being accurate. he refunded me $50 without me asking so i guess i'm o.k. with it,either way this radio is one helluva performer!
phil




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Zenith H725
hello Ed, how about that speacial tape used for ducting it's like foil or how about thin piece of aluminum roof flash...radiorich — 12:19 AM
Zenith H725
Ed; One material that I have seen, but never tried for this was material for making exhaust gaskets, it's similar to ...Arran — 11:42 PM
Zenith H725
I just remembered, I have some hi temp silicone rubber material which could do the trick. Or a piece of FR4 laminate. Th...EdHolland — 08:39 PM
Zenith H725
The PSU filter cap arrived today (thank you USPS!) so I will work on that later. Meanwhile, I have the dial, speaker...EdHolland — 06:42 PM
Philco 610B oscillator wiring
Thanks Terry. After checking my notes I think I recorded about -10v at the 6A7 G4/control grid. The screen grid (G3 &...Tubester — 05:59 PM
The list of my radio & TV collection!
Magical chords of forgotten melodies, old nostalgic music on an old radio... Saturday night blues on the Mid-Waves on an...RadioSvit — 12:20 PM
Philco 42-345 Restoration/Repair
Thank you MrFixr55 the issue with this radio is that the internal coil antenna is missing and there was a wire in its pl...osanders0311 — 11:34 AM
Philco 610B oscillator wiring
Regarding the oscillator circuit which is comprised of the 6A7's cathode, control grid, and screen grid. These elements ...Radioroslyn — 10:33 AM
Philco 42-345 Restoration/Repair
Hi OSanders, First off, welcome to the Philco Phorum where Phine Phamily-Phriendly Pholks Phull of Philco Phacts and P...MrFixr55 — 08:41 AM
Philco 42-345 Restoration/Repair
Today I've been reading through the site trying to learn more about this radio. I also soldered the lose power cord cabl...osanders0311 — 08:24 PM

[-]
Who's Online
There are currently 2392 online users. [Complete List]
» 1 Member(s) | 2391 Guest(s)
Avatar

>