Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1951 Studebaker philco radio
#1

Am looking for repair information for my Philco radio in my 1951 Studebaker. Any information will be helpful
#2

Some photos of the radio would be helpful. Also if you know the model of the radio (there may be a tag on it someplace) or at least knowing the model and year of your Studebaker could help us track it down.

Greg

"We are here to laugh at the odds and live our lives so well that Death will tremble to take us."
#3

Welcome,
https://sites.google.com/site/identifyin...studebaker

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#4

Welcome to the Phorum!
Icon_wave
#5

Need to know where to send my philco radio 6 volts for my 1951 Studebaker?
#6

There are some repair folks listed in the Resources section under "Radio Repair & Restoration".  You can contact them and check. You can also contact the folks at the Antique Wireless Association in NC and see if they have someone closer to you that might be interested in the repair. (I don't have any personal experience working with them.)




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM
Looking for verification of correct schematic.
I think you have the correct take on your set. Ron's annotated early schematics that note the below B22000 serial numbe...klondike98 — 12:04 AM

[-]
Who's Online
There are currently 1417 online users. [Complete List]
» 1 Member(s) | 1416 Guest(s)
Avatar

>