Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Phorum How-To #17: Mark Forums as Read
#1

Quite simple, really...

If you visit one of the forums within the Phorum, read the threads you want to read, and then want to mark the rest as "read" all at once - proceed as follows:

Let's assume you are in Philco Home Radios.

Look close to the top of the page, to the right of where it reads Philco Home Radios and under the big Post Thread button.

Look for the Mark this forum read link (see below).

[Image: https://philcoradio.com/images/phorum/Ph...17_001.jpg]

Click or tap it.

You will then see this message:

[Image: https://philcoradio.com/images/phorum/Ph...17_002.jpg]

The message will go away in a few seconds and you will be back on the main page of the forum you were in.



Now let's say you visit the Phorum, but don't want to read any of the threads in any of the forums. You want to mark all of them as "read".

Just scroll all the way down to the bottom of the Phorum home page and look for the Mark All Forums Read link as shown below (the view on phones is similar):

[Image: https://philcoradio.com/images/phorum/Ph...17_003.jpg]

Click or tap it, and then you will see this message:

[Image: https://philcoradio.com/images/phorum/Ph...17_004.jpg]

In just a few seconds, the Phorum home page will reappear.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Looking for place to donate unique Philco Philco J-1930 Prototype
Given the 1960s vintage, it is likely that the cartridge is ceramic, likely more stable. The changer looks like a Voice...MrFixr55 — 05:03 PM
Jackson 665 j2 schematic request
FIXED!daveone23 — 03:55 PM
Bakelite crack repair - what is best epoxy?
Thanks everyone. I appreciate you sharing your experience and looks like I'll work with the 24 hr two part clear epoxy....de371 — 10:25 PM
Jackson 665 j2 schematic request
Without a schematic its going to be hard tracing the wire wound spool resistors.daveone23 — 05:21 PM
Jackson 665 j2 schematic request
Looking for a schematic for the 665 j2 multimeter.daveone23 — 04:42 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
>>I'll write to the Henry Ford. I heard, his secretary answers his mail, not he himself.morzh — 12:15 PM
Philco 48-200 alignment questions
Just checked the power cord and I did in fact wire it so the hot side (small prong) goes to the switch.transitony — 11:52 AM
Looking for place to donate unique Philco Philco J-1930 Prototype
Thanks for the suggestions.  I'll write to the Henry Ford.   That would certainly make sense since by the time this prod...jeibner — 11:49 AM
Looking for place to donate unique Philco Philco J-1930 Prototype
For what it's worth, the Henry Ford Museum and Greenfield Village in Dearborn, Michigan may be an option. The obvious ...GarySP — 11:39 AM
Help with Readrite 410 tube tester
Mike and I just had a short discussion yesterday about this very subject. So often it's the connections. Ya gotta have t...RodB — 10:08 AM

[-]
Who's Online
There are currently 2260 online users. [Complete List]
» 2 Member(s) | 2258 Guest(s)
AvatarAvatar

>