Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Non Christmas Story radio
#1

https://vancouver.craigslist.ca/van/cbd/...36704.html

This is NOT the radio featured in "A Christmas Story", that was a Canadian Westinghouse 780X, not a 780Y, he even admits this in the fine print, but leaves the click bait out anyhow. Neither of these sets are rare as far as Canadian radios go, it has a 7 tube chassis, RF amplifier tube, single ended output, and a magic eye, so it was a mid priced radio when it was new, which means it was probably the one most people bought.

 I can't understand why this guy won't recap and re-resistor sets like this, early 40s Westinghouse sets are some of the easiest radios to work on, no rubber wire, big spacious chassis, no layers of parts. He will put a new magic eye tube in a set but won't spend $15 on new caps on a set he prices at $400. This is the same guy that claimed a 15 tube RCA set he had couldn't pick up much because it was 20 miles outside of Vancouver. If he spent as much time restoring his sets as he does coming up with lipstick, mascara, and B.S for his ads people would come to him. But maybe it's just as well, then someone else won't have to fix his handiwork later. I think his buddy has posted some ads trying to get $50 each for ST style #46 tubes, that aren't even of the same brand, let alone in matched pairs.
Regards
Arran
#2

Guy sure like to type!!!!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Terry;
  I thought I was bad until I saw his ads, complete non sequitur verbal diarrhea. Yes it's nice that you found a radio license belonging to a former owner of the radio, and he was a plumber who came over to Canada on the Carpathia in 1926, what does that have to do with the radio? Did you buy it from him? I suppose his favorite breakfast cereal was corn flakes?
Regards
Arran




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM
Made mistake & did not label connection
Maybe this is starting to make some sense in my hard head.  Is this why the wire in question was not in the great Ron Ra...georgetownjohn — 04:34 PM
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM

[-]
Who's Online
There are currently no members online.

>