Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Ron's RCA T7-5 Electronic Rescue

What does rating "A" signify stamped on chassis back side?

Paul

Tubetalk1

105-125 volts, 50-60 cycles.

There was also a rating "B" = 105-125 volts, 25-60 cycles; and a rating "C" = 100-130/140-160/195-250 volts, 40-60 cycles.

--
Ron Ramirez
Ferdinand IN

Hey, I know this thread is over a year old but it has and will be a great help for me as I am restoring this radio as well.

Thanks Ron

Jim
Spring Lake MI

Hey Jim, you live just down the road a piece. I'd like to see what you have sometime!

I just read through this whole thread. Ron's radio is virtually identical to my T8-18, except for not having the tuning eye tube. It was very interesting to see how we approached certain problems differently. I used a small pair of very thin needle nosed pliers slipped behind the pointer, and liberal PB Blaster applied to the shaft using a little paint brush, and managed to free it up to remove it. Mine had all replacement electrolytics, and I am not as much of a purist as Ron, so, with plenty of room beneath the chassis, I simply replaced the caps on the underside with new electrolytics with higher voltage ratings, 2 10 MFD and 1 20MFD. We both encountered the exact same candohm gone bad, and the same remaining good. My bad one had both sections gone, so I merely soldered new resistors of suitable wattage across the gaps in the candohm. Both our speakers were bad, and neither had a center spider. I don't think they originally had one. He sent his away, and I rebuilt mine myself. It was really interesting to read through the thread. Brought back a lot of memories of repairing mine. It now works great. I have been listening to the playoffs and now to the world series on it, sometimes on stations as far away as Chicago and Cincinnati. Great radios ! Tonight I am listening on WRVA 1140 in Richmond, VA. It's coming in like it was next door, not more than 300 miles.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Delco car radio Peko vibrator converstion issues
Rich, There is an Australian website (Cool386.com) that has much useful info regarding repair and restoration of vibr...Joe Rossi — 07:29 PM
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM

[-]
Who's Online
There are currently 3566 online users. [Complete List]
» 3 Member(s) | 3563 Guest(s)
AvatarAvatarAvatar

>