Posts: 74
Threads: 42
Joined: May 2008
City: Shinnston, West Virginia
State, Province, Country: USA
I am working on a Philco 41-315 Code 121. The pilot lamps are Push Button, Band Indicator - 34-2141, Scale Lights - 34-2064, and Cabinet - 34-2210. The bulbs are very difficult to remove. Any suggestions on how to remove the bulbs from the sockets would be greatly appreciated. Where do I find the information on the actual bulb numbers?
Thank you,
nv3g
Oscar
Posts: 120
Threads: 15
Joined: Aug 2017
City: Fort Worth
State, Province, Country: TX
I had same problem on a Philco 38-3. After reading Ron's article on rebuilding pilot lamps (see link below), I used a heat gun to soften the rubber so I could then extract the bulbs. Can't help on the bulb numbers.
http://philcoradio.com/phorum/showthread...pilot+lamp
Larry
Posts: 7,288
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
All of your philco numbers crossover to #44 bulbs.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
Posts: 74
Threads: 42
Joined: May 2008
City: Shinnston, West Virginia
State, Province, Country: USA
Thank you both for your prompt replys.
nv3g
Oscar