Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 89 (code 121) parts list
#1

I have looked for this and hope I haven't missed it somewhere. Can anyone point me to a parts list for the Philco 89 Code 121 cathedral? There is a bottom view of the chassis showing parts in Riders 3-34 with the schematic on 3-33, but I cannot find a page telling me what the actual parts are. I am mainly wanting to know the capacitors before pulling the blocks out. I know I can look at the block numbers and figure it out, but sometimes you have to pull it to see the numbers. I see a parts list for the 89 code 123, but numbers are different.
Thanks,
Scott
#2

Welcome to the Phorum! Icon_wave

Here's a must view link: http://www.philcoradio.com/phorum/showth...?tid=15002 that has the evolution of the model 89 showing the changes in the circuits over the years. Ron, our founder, put this together and should be very helpful. It does not have a list of parts but the schematics are very readable.

Also try: http://www.audiophool.com/Philco.html where you can view Service Bulletins #146 and #146B. They have lists for the 121 and 123 respectively. you need to download the djvu reader to view the images. If you have trouble let me know.
#3

Thanks Bob,
I can make it with those very easily.
Thanks Again,
Scott




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 5952 online users. [Complete List]
» 2 Member(s) | 5950 Guest(s)
AvatarAvatar

>