Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA R39
#1

I have a lead on a RCA R39. Looks to be  a Canadian built radio in reasonable condition. 8 tube TRF. Are these especially desireable?
#2

It's probably a "Victor" rather then an RCA is it was sold in the Canadian market. I believe that the R39 is one of the microsyncronous models, which debut for the 1929 model year, and were carried over until 1931, they have a funny arrangement with the tuning capacitors in order to allow them to be aligned to synchronize with the dial scale. The RF section is usually a series of #26 tubes as RF amplifiers, followed by a #27 detector, so not much different then an RCA Radiola 18 electrically, the audio amp and power supply is on the bottom chassis. In terms of value, well they are decent sets, not as good as a superhet, but with push pull #45s, electrodynamic speaker, and a heavy cabinet, they sound good. They are also fairly common, I think that Victor/RCA built something like 400,000 units over three years across all the models, so they are probably middle of the road in terms of value. At one time some guys had a scam of taking the power supply/amp chassis out, and pedaling them to Japanese audiophools as Western Electric amplifiers and speakers, so they used to be worth more because of that, until word got around the Orient that they were being swindled, now they are back down to where most late 1920s and early 30s consoles are. Be careful lifting these though, it's a two many job, the ones with a phonograph in top is a three man job.
Regards
Arran
#3

Thanks Arran!




Users browsing this thread:
[-]
Recent Posts
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM

[-]
Who's Online
There are currently 3625 online users. [Complete List]
» 4 Member(s) | 3621 Guest(s)
AvatarAvatarAvatarAvatar

>