Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Could these tubes be the originals?
#1

I have a Philco 66 on the bench. While testing the tubes, I noticed that ALL were branded PHILCO and had similar appearance and date codes. I had no luck on finding information on the web for early Philco tubes. This radio had had some servicing (volume control, line bypass cap) but was otherwise all original.

I was wondering if the tubes were the originals as shipped? All the codes are arranged vertically, with a LETTER and a NUMBER. The codes I found were (first figure on TOP) 78: 5C, 6A7: H5, 75: C5, 42: B4, 80: B4. Looks like a month (letter) and year (number) - but just guessing.

Does anyone have a reference on-line? I do NOT have Lud's book.

Thanks,
Dave
#2

The number is the last digit of the year. Letters are months: C is January, B is October and H is February. After September 1935 the month codes changed: B is February, C is March, H is August.

In either case it seems odd to have dates so far apart (I'm quite sure Philco did not stockpile tubes for months).

These are Sylvania codes, and it's possible Philco bought tubes from someone else, which would have different codes.
#3

Is this information in the book Tube Lore or another source? It is just curious that at least the YEAR is close to the introduction date of the radio. I would not suspect that the tubes would have been changed so soon. And they are all branded Philco.

Thanks!




Users browsing this thread:
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 5651 online users. [Complete List]
» 1 Member(s) | 5650 Guest(s)
Avatar

>