1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Canadian Model chassis 66? Ideas?
shawn1967
Junior Member
**
Posts: 12
Threads: 5
Joined: May 2018
City: Phoenix, AZ
#1

03-10-2019, 06:17 PM
Am helping a family on Cave Creek Az prepare father's collection of Philco radios for sale. Any Ideas on the specifics of this Philco Canada postwar model? Thanks!


Attached Files Image(s)
           
Find
Arran
Phorum Expert
*****
Posts: 4,682
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
#2

03-11-2019, 04:06 AM
It's basically like a pre war 42-327, but it's post war, with a different dial, post war knobs, and minimal rubber/gutta percha wire (if any).I don't think they are terribly valuable, but they are good performers, with two IF amplifier stages, I think, six tube AC/DC set. The dial looks like the paint is lifting off the back, so beware, hopefully it's just dirt on the front. Whoever brought it to Arizona likely brought it from Southern Ontario judging by the call letters, CHUM is in Toronto.
Regards
Arran
(This post was last modified: 03-11-2019, 04:10 AM by Arran.)
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 5395 online users. [Complete List]
» 1 Member(s) | 5394 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios