Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 41-605 code 121 schematic
#1

Good Morning, friends,
I am new to the phorum, so please be patient with me as I try to figure it all out!   Icon_biggrin 


I am spinning my wheels looking for a schematic for a Philco 41-605 code 121.  The code 121 is different than the 41-605 schematics available in Riders and Nostalgia Air and Radio Museum and pretty much every other place I've looked.  My technician explained to me what the difference is, but I'm just the dumb girl in the office, and I don't remember.  (I've also shown him the 41-603 and 41-625, and they are also not the right array.)

Additional information, as this dumb girl understands it, the top views on the schematic for the 41-605 are correct, but it does NOT match the wiring view (different number of cans and gangs).  So, maybe what I'm really looking for is a bulletin for the 41-605????

Any bright ideas you might have would be greatly appreciated.  I'd also welcome any dumb ideas at this point.

Thank you for your time and consideration.

Diane
#2

Hi Diane,

Welcome to the Phorum!

The service info we have on the Philco 41-605 is from the Philco 1941 RMS Yearbook:

https://philcoradio.com/library/index.ph...year-book/

Not sure if it's the same as what's in Rider's but since no code is specified it should implicitly be 121 (the default code). That info also includes changes in production that might apply to your particular radio as well.

Update: I took a quick glance at the Nostalgia Air schematic (comes from Rider's):
http://www.nostalgiaair.org/pagesbymodel...013430.pdf

From a basic glance the schematic itself looks the same although the RMS yearbook has more info.

Perhaps if you could find out what the suspected difference is or post a picture of the cabinet model label and/or chassis we might be able to better identify it.
#3

Diane

Tracing wires is not hard and as long as the schematic matches the wiring this is pretty much all you need.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#4

That is actually helpful, thanks. I saw the yearbooks but didn't think about there being additional info. If I can figure out how to add a picture, I will. The technician says he can make it work by eliminating (something) but he's also concerned about what else could be incorrect.

Thank you!!
Diane
#5

How to post pictures here in the Phorum:

https://philcoradio.com/phorum/showthread.php?tid=29

https://philcoradio.com/phorum/showthread.php?tid=4407

https://philcoradio.com/phorum/showthread.php?tid=4371

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>