Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

The BBC tests of a 48/482 Philco US model
#1

Hi Folks,

While trawling the net for other radio related stuff, I happened upon the BBC R&D department website. This has an archive of BBC white papers, covering all sorts of technical aspects of television and radio, and contains publications back to 1940.

While interesting in itself, I happened upon an item of direct Philco relevance, in which the FM section of the 48/482 AM/FM receiver was tested. 

The decade by decade archive starting point is available here:


https://www.bbc.co.uk/rd/search?Type=Publications


And the Philco specific paper is here:

https://www.bbc.co.uk/rd/publications/rdreport_1949_11

I hope this is of interest to the Phorum.

Cheers

Ed

I don't hold with furniture that talks.
#2

Interesting. Thanks for sharing, Ed.

No surprise to me about the 48-482's discriminator being found as inferior. Philco was trying to circumvent Armstrong's FM patents to avoid paying royalties.

I am rather surprised, though, that the American 48-482 would be available in Britain at all, and that the BBC would test it.

--
Ron Ramirez
Ferdinand IN
#3

Ron,

I doubt that set was available in Britain. According to Wikipedia (I'll do some more research on this) FM broadcasting was not introduced in the UK until 1955. However, the BBC would have been conducting tests, and would have wanted to evaluate how their signals would be received on consumer grade radio sets. In browsing the archives, I have found several receiver reviews including domestic and professional communications equipment.

I think I'll be downloading a selection of these for vacation reading. (Where's that nerd emoticon Icon_smile )

Cheers

Ed

I don't hold with furniture that talks.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently no members online.

>