Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-38 Mystery Part
#1

I'm considering picking up two consoles this weekend. My interest is mainly in a 610.  Due to a proviso that 'both must go,' I'm towing a 38-38 along with me. It will be my introduction to the farm radio experience which I am mildly excited about. I asked the seller if the radio had been upgraded for AC use only because he said it last played about ten years ago (haven't they all?) Anyway, he said it had a cord and plug and I noticed a contraption in the bottom of the cabinet which I did not recognize (see attached.) Can anyone please educate me on the purpose of this mystery part? Thanks in advance.


Attached Files Image(s)
   
#2

Looks like a power pack to allow operation on mains power. http://www.nostalgiaair.org/Resources/248/M0013248.htm     Looks like a fun project, or it could be the flux capacitor out of a time machine! Some more info https://philcoradio.com/phorum/showthread.php?tid=21485
#3

Thanks for the info David. That sounds promising about the former. Hedging my bets, does Riders contain a schematic for the latter? I may need it to go back and pick up the former.
#4

Might be one of these: http://www.nostalgiaair.org/pagesbymodel...017907.pdf

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#5

Great. Thanks Terry! I will definitely pore over that literature. I'm very green on radio repair in general so this will be a big help in trying to understand how these adaptors work.
#6

Some more info on a battery eliminator   https://philcoradio.com/phorum/showthread.php?tid=21451
#7

Thanks David and Terry for pointing me in the right direction on this. You guys were right on, as expected. I saw the Sears silvertone and Electro (pictured below) models of the battery eliminator and they look almost identical to the image I have. Thanks again, I really appreciate your help.


Attached Files Image(s)
       




Users browsing this thread:
[-]
Recent Posts
Need to purchase some accessories for restoration of my Old Philco Radio
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM
First Radio restoration
Hi Tubeman, Welcome to the Philco Phorum.  Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM
First Radio restoration
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM
Zenith H725
Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately. More ...EdHolland — 10:18 AM
Graphics for majestic 1050 dial glass.
Murf; I found this thread on the ARF, the first photo has a pretty good view of the dial glass. Regards ArranArran — 01:12 AM
Zenith H725
hello Ed, how about that speacial tape used for ducting it's like foil or how about thin piece of aluminum roof flash...radiorich — 12:19 AM
Zenith H725
Ed; One material that I have seen, but never tried for this was material for making exhaust gaskets, it's similar to ...Arran — 11:42 PM
Zenith H725
I just remembered, I have some hi temp silicone rubber material which could do the trick. Or a piece of FR4 laminate. Th...EdHolland — 08:39 PM
Zenith H725
The PSU filter cap arrived today (thank you USPS!) so I will work on that later. Meanwhile, I have the dial, speaker...EdHolland — 06:42 PM
Philco 610B oscillator wiring
Thanks Terry. After checking my notes I think I recorded about -10v at the 6A7 G4/control grid. The screen grid (G3 &...Tubester — 05:59 PM

[-]
Who's Online
There are currently no members online.

>