Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA 45-EY-3
#1

OK Some problems with this Recapped all .. Electrolytic and all other caps.. Did not change any resistors. All were withing spec.. I did change all three tubes Same problem...

The cam in middle is all messed up.. But I think that should not cause the player to not work..

player spins and when needle is put on record i can hear it a little .. Turn volume up all the way and extremely low volume

If I pick up the needle and scratch it I can her a load hum.. So I assume the amp part is working..

and the cartridge also.. So why NO good sound??

Help

Skip
#2

If you are still trying to use the original sodium cartridge, you won't get much. They are always DOA and need to be replaced.

No matter where you go, there you are.
#3

Ok.. Even if I scratch the needle and get noise?

Skip
#4

Yep. Sometimes a cartridge will have a little life left in it and make sound that way, but still be weak. Finding a more modern cartridge that you can adapt in is a better choice. If nothing else, it is way lighter and friendlier on your records!

No matter where you go, there you are.




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM
Looking for verification of correct schematic.
I think you have the correct take on your set. Ron's annotated early schematics that note the below B22000 serial numbe...klondike98 — 12:04 AM
Looking for verification of correct schematic.
Hello Ross. The Philco Radio Library located at the bottom of the page has the schematic with the tube count you have. ...GarySP — 10:48 PM
HiFi (Chifi) tube amp build - but my own design.
Tim It's be interesting if you put your schematic here. Who knows, you could get some advice from a few folks here. ...morzh — 10:01 PM
Philco 42-390, code 121 speaker
Thanks for that information. It would appear from the output transformer parts list that the transformer that was origi...Stevelog — 07:21 PM
Looking for verification of correct schematic.
I would like to verify that my thoughts are correct regarding my Model 70 and its appropriate schematic. My chassis inf...RossH — 06:26 PM
Philco 42-390, code 121 speaker
Welcome to the Phorum, Steve! The Philco Radio Library located at the bottom of the page has info on speakers and outpu...GarySP — 06:24 PM
Philco 42-390, code 121 speaker
I recently became the owner of a Philco console 42-390, saving it from the dumpster.  It is missing the speaker. It uses...Stevelog — 12:07 PM
Help identifying
Thanks for the welcome, Gary. There exists only one photo of the unit in the Richard Neutra-designed home. The photo (th...Davino — 10:54 AM

[-]
Who's Online
There are currently 603 online users. [Complete List]
» 2 Member(s) | 601 Guest(s)
AvatarAvatar

>