Philco 41-300 Tone Control Knob Removal

Register

Guest Join Us

Hello Guest,

Please feel free to join us!
There are many more parts of the Phorum that only members can see.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Philco 41-300 Tone Control Knob Removal

radiodale
Member

Posts: 93
Threads: 20
Joined: Aug 2014
City: Greenville, TX

#1

10-11-2020, 04:29 PM

10-11-2020, 04:28 PM

How do I remove the brown knob? Cannot rotate it any further CCW.

Dale

http://www.dalesantiqueradio.com/

Radioroslyn
Phorum Expert

Posts: 7,248
Threads: 266
Joined: Dec 2009
City: Roslyn Pa

#2

10-11-2020, 06:59 PM

I got one apart a couple of yrs ago but done remember how. Can you loosen the nut on the pot and manipulate the shaft/gear on an angle to slip thru the hole? They put it together so it's got to come apart. Don't think they welded the gear on after the knob was fitted.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

View a Printable Version

Users browsing this thread:

Recent Posts
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM

Who's Online

There are currently 3614 online users. [Complete List]
» 3 Member(s) | 3611 Guest(s)