Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Cleaning paint from 46-420 bakelite case
#1

Hello Experts,

I'd like some suggestions for the gentle removal of paint spots from a really nice Hippo bakelite cabinet. It polished up really nicely, but at some point it got flecked with paint. I can, with great effort, clean up each fleck with a fingernail. Maybe some has a gentler method.

Thanks,

Dave
#2

Rubbing compound on a Qtip or a dental pick easy on the pressure. David
#3

My favourite paint spot tool is a razor blade scraper, the type where a hard backed safety blade slides into a holder. I always round of the corners of the blade on sandpaper so they won't catch and scratch, then hold the scraper on a shallow angle and be gentle. They usually come right off.
#4

Thanks for the suggestions. Good Deal.
#5

Bakelite is resistant to solvent paint remover but not a caustic paint remover. Some Bakelite will be O.K. with oven cleaner lye. But I would not use it.

Never clean Bakelite with Windex, 409 or other "super" household cleaners. They can remove the top surface and permanently leave the finish dull.

Mechanically removing the paint has risks...  chas

Pliny the younger
“nihil novum nihil varium nihil quod non semel spectasse sufficiat”
#6

if its latex house paint xylene or sold in hardware stores as "goof off" will work




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Made mistake & did not label connection
Hi John, I don't have this radio, but I can supply some info: Based on your pic, pins 7,8 and 1 are used together, go...MrFixr55 — 02:02 PM
New Philco Repair Bench
As far as I know, the Repairbench does not work, and has not been working in a while. Chuck (we had that campaign looki...morzh — 01:33 PM
Radio city products 664 schematic request
Need a schematic or manual for the 664. The 663 may be similar.daveone23 — 12:38 PM
New Philco Repair Bench
Thanks Gary.dconant — 12:16 PM
New Philco Repair Bench
I tried accessing the site through our library and got the same response. It's reported to our tech gurus. GaryGarySP — 11:50 AM
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM

[-]
Who's Online
There are currently 5014 online users. [Complete List]
» 2 Member(s) | 5012 Guest(s)
AvatarAvatar

>