Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Another 41-295 radio
#1

I picked up another Philco 41-295, it’s in better condition than the last one. Only payed $40 for it. I have already striped the cabinet, with lacquer thinner, and acetone (50-50) it cleaned up nice. Used a sanding sealer from mohawk, and then grain filler. Some light sanding, then some medium walnut toner from Mohawk. Then just started ultra flo clear lacquer. But I need to replace some decals like on the faceplate, and also the Philco logo on the front of the cabinet. 

I ordered the decals from “Radiodaze, but the ones that came in were not right. They don’t list them by model number, so I’m not sure which ones are the right ones. Any help would be very appreciated.

Will upload pictures later.

Michael

Philco 41-295X 4 band radio.
I'm 67 years old, in north Idaho.
#2

   
   

Hers some pictures

Philco 41-295X 4 band radio.
I'm 67 years old, in north Idaho.
#3

See this link in the gallery... https://philcoradio.com/gallery2/1941a/#Model_41-295X
Looks just like your radio.
#4

Ya I know what it looks like, I have 2. I need to figure out what decals for the face plate. From radiodaze.

Philco 41-295X 4 band radio.
I'm 67 years old, in north Idaho.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently no members online.

>