Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

New here
#1

Just had come my way a Philco Radio so while hunting out some info found this site ,seemed a good idea to join

I have been collecting and fixing Vintage electronics for many years now
#2

Welcome to the Phorum! You found the right place for Philco radios in particular, but also most every other brand built as well. Lots of friendly folks here willing to help any way we can. Take care and BE HEALTHY! Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
#3

Hi and Welcome aboard, 

What sort of Philco set did you find a US or Brit built one? It's always a treat to see the non US set as they are pretty common over here. Especially the pre war models.
Here at the Philco Phorum Philco's are our speciality!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#4

Welcome!

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#5

Welcome to the Phorum!
Icon_wave
#6

Welcome to the Phorum. Like the handle "Fixitnow" is better than laterIcon_smile.

Paul

Tubetalk1
#7

Hello FIXITNOW,
Welcome aboard and glad to see you found your way here .
So What kind of Vintage equipment do you like collecting or working on ?

Sincerely Richard
#8

I have about 8 sets that need to be fixed "now". Paul

Tubetalk1
#9

Welcome to the website, Hope to hear from you now and then.  Icon_wink
#10

Welcome to the Phorum. David
#11

Hello Fixitnow,
Welcome aboard !
Sincerely Richard
#12

Welcome to the Phorum FIXITNOW Icon_wave

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently no members online.

>