Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

i just got a Philco chairside
#16

I have the radio all recapped and it sounds very good, no hum, and loud and clear.
 I am just waiting for some safety caps.  the cabinet won't get done until next spring.
 Dan in Calgary

   Living in Calgary Alberta
#17

Hello Dan,
Way to go !!!

Sincerely Richard
#18

Hi Dan,

Looks good! You haven't told us what model chassis is in it...Canadian?
#19

I don't think it is Canadian,and I am not sure how to find out .
       The model is 38-15. [121-124]
  I got the schematics from my Riders book.
 
              I just ordered a bunch of caps from Just radios ,and that was before I knew I needed safety caps.
 To make a special order would be too costly.
      I would gladly pay one of you guys to send me two .01 y caps in the mail. I have pay pal.
    Thanks
 Dan in Calgary

   Living in Calgary Alberta
#20

Dan,

Check your PM.

--
Ron Ramirez
Ferdinand IN
#21

Thanks Ron;  All the guys on the forums are great and always willing to help out others.
 Thank you very much
 Dan in Calgary

   Living in Calgary Alberta




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

[-]
Who's Online
There are currently no members online.

>