Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Need help with info identifying my Radio
#1

I picked up a Philco Radio at an auction recently, and I'm having a little bit of a tough time identifying it. I'm pretty sure it is a 1933, and I'm pretty sure it's a model 19, but the code is 123, which I can't seem to find any information on. I see a code 122, 126, 128, but I don't see anything about a 123. This is my first old Philco, so I know absolutely nothing about them. Any information you guys can give me would be greatly appreciated. I have some other questions about it, but I figure I'll start with general info on the radio.

Note from site admin: Sorry, but the photos which were attached to this post are no longer available.
#2

You can get photocopies of original Philco service lit through my website.
See the Schematic Info page for all the details.

Chuck
#3

Hello, Krick27, and welcome.

Very nice find! The 19B in the older Code 123 configuration is not as common as the more easily found Code 126. This is the first 19 to add the "police" band and a fourth knob; the 19-121 and 19-122 were AM only with 3 knobs.

Yes, it is from 1933.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5068 online users. [Complete List]
» 1 Member(s) | 5067 Guest(s)
Avatar

>