Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

What did I buy?
#1

http://cgi.ebay.com/130495289420
Can anybody tell me if it is a model 60MB or a 66B? Had a model 60MB years ago.
Tnx!
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#2

Impossible to tell from the photos. Good luck stripping the brown paint from that thing.

--
Ron Ramirez
Ferdinand IN
#3

I thought that would be the answer. Couldn't be worst that that model 20 cabinet!!!
Tnx
Terry Hoping for a 66B

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#4

The shortwave dial on a 66 goes to 16.0 MHz, the 60 only goes to 4.0 MHz
#5

Yeah I'm hoping it the 66 as it does better SW coverage. I've the 60 in a cathedral cabinet.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#6

Hooray!!!!! It's a model 66B. Everything looks good but the dial escutcheon is worn off sanded maybe? Should be a fun project to get going again and cruise the SW band!
Terry
ps anybody got an escutcheon for 60mb or 66b?

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Testing a speaker and output transformer Trutone A2-G
Well I have found 315v on the rectifier when cold. Drops off to 280 after 15 minute warmup. Checked pin 3 on both 6F6 t...murf — 04:14 PM
Testing a speaker and output transformer Trutone A2-G
Thanks for the replies, I will check these ideas out and report back. murfmurf — 03:18 PM
Testing a speaker and output transformer Trutone A2-G
Sorry, my mistake. murfmurf — 03:07 PM
Testing a speaker and output transformer Trutone A2-G
MrFixr Honestly, I haven't done that yet and do not want to screw up the threads; maybe you could do it, or we could...morzh — 12:48 PM
Two small radios from France. Restoration and review.
Greetings; I think that it's possible that the assortment of components was the result of post war parts shortages, a...Arran — 12:18 PM
Philco model 38 code 121 not receiving signal.
Unfortunately I can't inject any audio into the volume control. It is in the primary circuit of the antenna coil, not in...Stormlord5500 — 09:32 AM
Philco model 38 code 121 not receiving signal.
Sounds good Gary I'll do that. I have plenty of stuff like that I can scrounge up. I am still kind of new to all this so...Stormlord5500 — 08:47 AM
Philco Battery-WWII vintage
Seems to me that this a general purpose or radio filament 6V battery of very high amp-hour capacity and very high "...MrFixr55 — 08:08 AM
Testing a speaker and output transformer Trutone A2-G
Hi Morzh, From my end, no. I did not know that there are 2 threads on this topic. Maybe it should be combined.MrFixr55 — 07:13 AM
Testing a speaker and output transformer Trutone A2-G
Any reason for the 2nd copy of the thread?morzh — 10:22 PM

[-]
Who's Online
There are currently 320 online users. [Complete List]
» 1 Member(s) | 319 Guest(s)
Avatar

>