Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Volume Decreases and Increases on it's own-the 39-6C
#1

I completely restored this radio inside and out--and it's a beautiful little set that plays quite well. I had to replace it's output transformer and rewire the main transformer. It was quite dirty when received. The problem is when it's playing, the volume decreases down to about half the db.-then back up on it's own- all within several seconds. When it warms up, it (usually) doesn't do that any more. Any suggestions? Thanks!!!!!
https://picasaweb.google.com/lh/photo/nL...directlink
#2

My first thought is a tube filament (heater) that is intermittently opening up. Turn the radio around so you can see the back and watch the tubes. Wait until the set has cooled off for awhile, then turn the set on and watch the tubes (in dim light so you can see the glow of the heaters). When the volume drops, see if one of the heaters has gone out or appears to slowly go out, then come back as the volume begins to increase again.

If all five remain lit steadily, then your problem is elsewhere and signal tracing should reveal the faulty stage.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM
Made mistake & did not label connection
Maybe this is starting to make some sense in my hard head.  Is this why the wire in question was not in the great Ron Ra...georgetownjohn — 04:34 PM
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM

[-]
Who's Online
There are currently no members online.

>