Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 16B Tombstone question
#1

Hello, all: any suggestions for what color/product to use for the light colored lines that go up the 3 bars of the grillework and parallel across the lower face?

I am about to start shooting the cabinet with clear and wanted to get the detail the correct color before I do.
#2

If you can find nail polish in a tan color, that would be a good choice. Nail polish is lacquer, and won't interfere with your lacquer spray.

Don't use yellow, or white, or ivory. Ivory is too light. Tan is about right.

Another choice is brush-on auto body touch-up paint, which is usually lacquer also.

It may take some searching, but hopefully you will find something suitable.

--
Ron Ramirez
Ferdinand IN
#3

Thanks, Ron. Those are some great ideas. Yes, I was concerned about making sure that the medium that I used for these details did not interfere with the rest of the laquer finish.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM

[-]
Who's Online
There are currently 4000 online users. [Complete List]
» 3 Member(s) | 3997 Guest(s)
AvatarAvatarAvatar

>