Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

US Gloritone
#1

Well, I finally did drag home a radio from Canton, OH tonight. Found a radio advertised as a 'US' radio on Craigslist a couple days ago for $44. I decided to check about it tonight and brought home a bit rough, but complete six-legged conole. Not very big with a six tube chassis. The tag inside claims it to be a US Gloritone model 3074. Basically the low end mate to my dad's 11 tube US Apex console. I'll try and post some pictures soon. Although they are very wobbly, at least the legs are intact.

No matter where you go, there you are.
#2

As I promised, a picture of the radio.[attachment=0]
Couldn't find a print for the radio, so my friend recapped it by reading and testing the old parts for reference. Did well up at his place, but the type 55 tube might be suspect. He's got miles of antenna, so it picked up well up there, but isn't very strong at all down here. I think I have a good 55 in one of my other radios, so might try a swap.

No matter where you go, there you are.
#3

Yes,
U.S. Radio & Television made the Gloritone and Apex sets plus a lot of the Airline sets for Monkey Wards. They were located in Marion, Ind. before being bought out by Grunow in '33' located in Chicago.
#4

John R Wrote:Yes,
U.S. Radio & Television made the Gloritone and Apex sets plus a lot of the Airline sets for Monkey Wards. They were located in Marion, Ind. before being bought out by Grunow in '33' located in Chicago.
Ah, so that's what happened to US Radio & Television. I also have a Mantola with the Apex 27 chassis in it from the 29-30 period. The Gloritone is working decently now, but the speaker is touchy and develops cone rub unless you have the volume and tone adjusted just right.

No matter where you go, there you are.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently no members online.

>