Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

PHILCO 70 VS 90
#1

I am looking to obtain a Philco Cathedral. I have seen a number of 70's and 90's for sale on E-Bay and elsewhere. Is the 90 that much of a better performer than the 70 that it is priced so much higher at auctions, etc? From what I have read, the 70 performs quite well and there isn't that much of a difference between the two except for two tubes.

Any insight would be helpful.

Thanks to all
#2

Hi Madghost,
There are some differences. Just glancing at the schematic the 70 volume control is in the antenna circuit. The 90 has its own 2nd detector and avc. The 70 looks to me that it doesn't. Also The volume is also controlled by changing the bias on the cathodes of two of the 24 tubes on the 70. The 90 also has two stages of audio amplification before the final output tube. The 70 uses the same tube as the 2nd detector and audio amplifaction.
I'm sure Ron and Chuck could tell you more. Both of my 90's play great. With a good antenna I pick up many stations across the dial. Sorry to say I have never listened a 70. Icon_sad

Hope this helps
Terry
#3

And there are three versions of the Mdoel 90, the origninal; Early, Mid and Late.

See the Early Cathedrals section of my site.
#4

Hi Madghost

The early 70 and early 90 (using two Type 45 output tubes) share the same front end, and neither have AVC.

The "mid" 90, the most common version with a single Type 47 output, uses AVC which makes a HUGE improvement in performance; i.e. no "blasting" as you tune across the dial, and less prone to fading.

The late 90 (push-pull 47 outputs) and late 70 both have autodyne converters, and both have AVC, so again their front ends are similar.

Both are good performers. To make a long story short, the 90 has extra amplification in its audio section. It is slightly larger than the 70. And there is just something special about it, I guess, that makes it more desirable. Icon_smile

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
IF can wire size and Rubber mounts?
Hello PHORUM members, I am still working on restoration of my PHILCO 37-640.  I want to start with rewiring the IF ca...georgetownjohn — 06:32 PM
Philco 41-608 changer coupler
I am working on a Philco 41-608 with the gear-driven changer.  The coupling (#35-2220) between the motor assembly and th...alangard — 06:29 PM
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM

[-]
Who's Online
There are currently 2616 online users. [Complete List]
» 2 Member(s) | 2614 Guest(s)
AvatarAvatar

>