Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Rare Philco find but a mystery ?
#1

Sorry for the delay in putting this up have been busy.
Picked this up on Sun. and it is a bit of a mystery?
It is a rare 200x radio, and has a radio spec tag and chassis for a 201x chassis? But It was also pointed out to me that there is also a small tag on it that says 200x?????? It even has the original back cover.

Buy the way it is not for sale, someone very dear to all of us here on this forum is getting.

Rock


Attached Files Image(s)
                   
#2

more pics


Attached Files Image(s)
       
#3

My opinion: I believe this set is a 201 chassis in a 200X cabinet, and it was done by Philco at the factory. I would guess this set was built at the point of transition from model 200 to 201, and Philco had a few 200 cabinets left over, so out went the first few 201X sets in 200X cabinets.

It wouldn't be the first time Philco had pulled a stunt like this...leaving us scratching our collective heads decades later.

Whoever is getting that set is one lucky fellow and, no doubt, a very happy fellow as well!

--
Ron Ramirez
Ferdinand IN
#4

Definitely agree!! There are numerous documented cases of this that can be found here in the Phorum.

I have a 38-2650 in a model 37 tombstone cabinet, and also have a 1935 model 16X with a five-band '34 model chassis.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Usually a wave trap is for keeping IF signals from entering the antenna and from leaving the antenna. You feed an IF sig...RodB — 09:30 PM
Philco 60 Squealing
I just peaked it for the best signal at 600. NULL it for IF frequency, originally it would have been null for 500kh...Chas — 08:05 PM
Philco 60 Squealing
Wavetrap no longer matters.morzh — 05:19 PM
Philco 60 Squealing
Rod, I had checked out your suggestions but did not help. I did solder the ground rivets to the chassis as Chas suggeste...dconant — 04:52 PM
37-690 Bass Choke Replacement
Yeah, I know, Mouser and Digikey don't have "big iron" components. For some reason Philco was messing with the...Radiodial — 04:25 PM
37-690 Bass Choke Replacement
Yes, I just had to deal with that while repairing the 37-604 Philco. Exactly that value choke was gone. And the current ...morzh — 03:52 PM
37-690 Bass Choke Replacement
Ah, now where to find one. I've into this before on smaller sets, I now recall. Hammond makes one that is only rated...Radiodial — 03:27 PM
Philco 38-7 Speaker
Ask the admins to put them together. As for the renaming, while inside the thread, you simply press "New reply&quo...morzh — 02:23 PM
37-690 Bass Choke Replacement
This is the parts catalog. 32-7528 choke is 65H, 10mA, 2,250 Ohm inductance. Find a suitable one.morzh — 02:18 PM
37-690 Bass Choke Replacement
While troubleshooting the no bass amplification issue, I think I found the culprit. The choke #104 is reading 164K ohms....Radiodial — 01:42 PM

[-]
Who's Online
There are currently 2452 online users. [Complete List]
» 4 Member(s) | 2448 Guest(s)
AvatarAvatarAvatarAvatar

>