Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 77 request
#1

I'm working up a cap order for some projects. On my 77, it appears that there was a cap box on top of the chassis and someone removed it and then put a few caps in its place and then put the rest underneath in an ugly soldered-in-mid-air technique. While I await Chuck's paperwork, could someone tell me what the caps are in that box?
#2

Three 2.0 uF and one 0.15 uF. All 600 - 630 WVDC if you go with the yellow wrapped film type, which will last longer than the equivalent electrolytics.

http://www.philcoradio.com/tech/images/77.jpg

--
Ron Ramirez
Ferdinand IN
#3

And (this seems to be a standard arrangement in Philcos' power filter) 0.15uF across the choke does not have to be 630V. It can be 100V for all I know. Actually this is what I put in.
#4

Thanks....this will be quite an adventure when I get the paperwork. The current caps are a 20/20, two .25s, a .005 and a .05.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 665 j2 schematic request
FIXED!daveone23 — 03:55 PM
Bakelite crack repair - what is best epoxy?
Thanks everyone. I appreciate you sharing your experience and looks like I'll work with the 24 hr two part clear epoxy....de371 — 10:25 PM
Jackson 665 j2 schematic request
Without a schematic its going to be hard tracing the wire wound spool resistors.daveone23 — 05:21 PM
Jackson 665 j2 schematic request
Looking for a schematic for the 665 j2 multimeter.daveone23 — 04:42 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
>>I'll write to the Henry Ford. I heard, his secretary answers his mail, not he himself.morzh — 12:15 PM
Philco 48-200 alignment questions
Just checked the power cord and I did in fact wire it so the hot side (small prong) goes to the switch.transitony — 11:52 AM
Looking for place to donate unique Philco Philco J-1930 Prototype
Thanks for the suggestions.  I'll write to the Henry Ford.   That would certainly make sense since by the time this prod...jeibner — 11:49 AM
Looking for place to donate unique Philco Philco J-1930 Prototype
For what it's worth, the Henry Ford Museum and Greenfield Village in Dearborn, Michigan may be an option. The obvious ...GarySP — 11:39 AM
Help with Readrite 410 tube tester
Mike and I just had a short discussion yesterday about this very subject. So often it's the connections. Ya gotta have t...RodB — 10:08 AM
Looking for place to donate unique Philco Philco J-1930 Prototype
We have a regional museum here in the Twin Cities called The Pavek Museum. They have an extensive collection of communic...RodB — 09:30 AM

[-]
Who's Online
There are currently 2262 online users. [Complete List]
» 1 Member(s) | 2261 Guest(s)
Avatar

>