Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Fun with LED Lamps in Philco Sets
#16

Such as the behavior of these LEDs, if placed in the series of the valve.
#17

my 42-380 with led's i think it looks good.[Image: http://i1281.photobucket.com/albums/a508...9e1c5c.jpg]
#18

Ronin61 - Icon_thumbup

Which type of LEDs did you use in your 42-380?

--
Ron Ramirez
Ferdinand IN
#19

They are 4 led bulbs from pinball life direct replacement for 44 and 47 bayonet mount. Amber in color. I purchased single,triple, and quad led's to try in my Philco 645k, really lights up that dial.
#20

I think I like those ambers better than the warm white ones I have.

-Mars
#21

The ambers really look cool! 
Where did you get them from?
_________________________
Alexandra
24v led puck lights




Users browsing this thread:
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 3833 online users. [Complete List]
» 1 Member(s) | 3832 Guest(s)
Avatar

>