Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Vibrator needed for superhetero
#1

I need a vibrator for a philco superheterodyn. I took a picture of the back of the radio. I don't know how to upload it. Well I guess my pic is to big to upload. Let me know info. You may need to I can get the right part. Thank you
#2

Dave,

Info on how to post a picture is in the PHORUM 101 SECTION.
"How to do things on the Phorum"
http://philcoradio.com/phorum/forumdisplay.php?fid=27

In there you'll find directions. Scroll to bottom of listings.

Chuck
#3

Hi and welcome to the Phourm!
If you can come up with a model for the radio that would be a big help!!
What part of Pa are you in? I'm over near Philly.
Terry
#4

I read it as "Vibrator needed for superhero" and tried to imagine that vibrator....then I realized I needed to re-read the topic. Icon_lol
#5

morzh, I'm glad I'm not the only one who made that mistake Icon_lol




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>