Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help Identifying radio
#1

Hi Everyone - I am inheriting a radio and I would really like to identify it so I can begin restoring. Unfortunately it looks to be missing a plate on the front and there are no labels that I can find so it's been tough so far. Based on what I've found in the gallery and through my own research I believe it to be Philco Model F possibly...

Does anyone recognize this type of radio?

Thanks!


Attached Files Image(s)
                   
#2

Looks like a 1933 Airline Radio. Can you post a clear pic of the chassis and tell us how many tubes there are and what kind they are?
#3

Nice, I hadn't heard of those yet. I just updated the pics above, do those help? I believe there are 4 tubes. Thanks!
#4

Based on what you said, i did find a very similar looking radio here:

http://www.radiomuseum.org/r/montgomery_...e_119.html

I inspected the radio it does look like there used to be a few pieces over the speaker area that were broken off. the major difference though between mine and the one in the link above is the presence of a fourth knob. The radio in the link has one extra than what mine has.
#5

It has ten tubes, there are more tubes inside the aluminum cans. It's too bad that the dial escutcheon is missing and the speaker grille is broken out. It should be possible to find another escutcheon with some searching, as for the grill that could be replicated but you would need to make a pattern from the grille in an identical cabinet.
Regards
Arran
#6

i'm keeping my fingers crossed that my family has the dial escutcheon somewhere as they thought it was on there originally when we got it. as for the grillle pattern, how would you recommend I go about finding another to make the pattern from?
#7

Most likely made by Wells-Gardner, who was a major supplier of radios for Montgomery Wards (Airline). They used that same dial on other models, so you might get lucky and find an escutcheon that fits.

Tim KA3JRT




Users browsing this thread:
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 6974 online users. [Complete List]
» 2 Member(s) | 6972 Guest(s)
AvatarAvatar

>