Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Just got afew new consoles
#1

http://www.flickr.com/photos/53710524@N0...hotostream

Much tnx to Rockeeter for making this possible and for saving all the little bits and pieces from one junk set. This made it possible for me to build up a 116X from his spares and a $10 cabinet I picked up today from Epay. Now I have two!!
Now for the fun after I get the Packard car radio done(just about ready to give it back to the owner) I can start on one of these puppies!! Or one of a few hundred projects.
Terry
#2

Good going, Terry!

Will you be going to Kutztown in a few weeks?

--
Ron Ramirez
Ferdinand IN
#3

Not sure. Work on Saturdays and Sunday can be a little tough to get away. Awhile back I picked up a 650 that is pretty rough but I think I can salvage enough of the grill cloth (it's pretty rough too) from it the repair the torn pieces over the two clairfiers on one of the sets.
Terry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM
Made mistake & did not label connection
Maybe this is starting to make some sense in my hard head.  Is this why the wire in question was not in the great Ron Ra...georgetownjohn — 04:34 PM
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM

[-]
Who's Online
There are currently 3525 online users. [Complete List]
» 5 Member(s) | 3520 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>